![]() ![]() Balancing between budget and quality is the hardest job in the world of instruments, but Yamaha’s somehow got through it with the FG800 and FS800. 3 Conclusion about Yamaha FG800 vs FS800Ĭheap and playable guitars, which are always recommended for beginners, are bad investments as they can’t stand against extended practice and usage.1.3 Amazing scalloped bracing of Yamaha FG800 and Yamaha FS800.1 The similarity of Yamaha FG800 vs FS800 reviews. ![]() I hope that I've answered your questions. Using the block as I described will give some of the benefits of a hot press but it has to be done slower. The problem can get so bad that only a hot press will put relief back in the neck under normal string tension. ![]() Once in a while a bass comes along that with a fingerboard/neck that tends to cancel out relief as the wood ages. The only reason that you would ever loosen a truss rod should be to add relief to the neck. The title of the thread is "Can't Loosen Truss Rod Enough". the neck will maintain the relief when the block is removed if the truss rod is promptly adjusted to hold eveything in place. By loosening the truss rod completely you are assured that the truss rod doesn't prevent the strings from adding relief.īy temporarily changing the angle of the string tension the relief is forced into the neck. The tension from the strings can only add relief. The tension that the truss rod puts on the neck can only remove relief. Note: If you feel you need this adjustment to be made and you're not comfortable with the procedure, take your bass to your authorized Service Center.Ĭlick to expand."A question though, how can he use a 1 inch block to gain relief when the truss rod "It's completely" loose."? The pitch of the neck on your bass has been preset at the factory and in most cases will not need to be adjusted. Retighten the neck screws when the adjustment is complete. Tighten the hex screw with an 1/8" hex wrench approximately 1/4 turn to raise the action approximately 1/32". For those basses with the Micro-Tilt adjustment, loosen the two neck screws on both sides of the adjustment access hole on the neckplate by at least 4 full turns. 010" thick will raise the action approximately 1/32". A shim approximately 1/4" wide x 1 3/4" long x. To properly shim a neck, the neck needs to be removed from the neck pocket of the body. The need to adjust the pitch (raising the butt-end of the neck in the pocket, thereby pitching the neck back) of the neck occurs in situations where the string height is high and the action adjustment is as low as the adjustment will allow. It replaces the need for a shim by using a hex screw against a plate installed in the butt-end of the neck. On a few basses, a Micro-Tilt® adjustment is offered. A shim is placed in the neck pocket, underneath the butt-end of the neck. Shimming is a procedure used to adjust the pitch of the neck in relation to the body. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |